Recent content by jason celaya

I figured I bring this thread back again as I too am thinking of upgrading my 3802 w/ a 2 ch. POA 5200 (2 x125)to a 5803 and I'm wondering if it would be worth it. I think power will not be too noticable however I wonder if I could tell the differece in DACS on HT. Any more input?

Unfortunately, NO.....It still depends on your room response and equipment. Another factor I think is how loud do you listen to movies? If you watch at relatively low levels a "hot" mix may be not so bad. Generally, if listening at reference levels most movies can benefit from THX when watching...

Stick with the M&K.

I LOVE M&K my favorite for movies and music

Also, I believe that Polks are more efficient speakers. You typically are going to need a bit more stable power to run the M&Ks as many of their speakers have a 4 ohm impedance.

I went from polks to M&Ks, and while the polks were no match in clarity they definatley not as bad as many on the forums make them sound. They M&Ks tend to be able to play very loud without introducing much distortion (the polks couldnt keep up) .The Polks are however nice warm speakers and do a...

My wife wants them too. Is the quality at least better than the VHS?

the firmware i believe will only fix the chroma bug. The stuttering is yours to cherish. I returned my 3800 and bought the cheapo 1600. Way more realible and picture is just as good.

I just upgraded from the 2500 to the htps 7000. The sound was a huge improvement. The picture improvement was nominal from the two units howver compared to being plugged straight into a wall the improvement is great.

cool, thats all i needed to hear. I'll leave it as is.

I am currently running a 3802 with a denon POA 5200 125 x2 amp on the front two channels and I am pretty happy with the result. I have been thinking however, would it make more sense to use 1 of the 2 channels for the center speaker being that it is the most used in a movie. I do not listen to...

tweeters across front need to be at ear height or aimed to ear in order to get the most out of this model. They have a wide horizontal axis but for correct imagining the vertical should be dead on.

M&Ks are also in the realm of great subs.

I think that they are awesome! I would go with either there 750 set (3 750s 2 550s and 1250 sub) or the new 850 set which was annouced this week. You should be able to get them at 33% off list. 2 things to think about with me suggestion. Does your Sherwood have good power into 4ohms and a...

denon plus amp is the way to go. BtW does the yammie have adjustable crossovers? I thought that they set them all to 90hz