verynew
Auditioning
- Joined
- Oct 10, 2010
- Messages
- 1
- Real Name
- Erik
I am just beginning to learn about home theater. I purchased a surround sound system for new home that I had pre-wired. I am having my first problems after being set up for 2 months. I have a Yamaha RX-V665 receiver, 600 series Definitive Technologies 5.1 speakers and a Sony Blu-Ray and TV, and Direct TV satellite. I also have the second zone set for external speakers but I was not using them when the problem occurred.
During middle of IRON MAN2 Blu-Ray, the receiver shut down. I turned back on and get same results. I shut down AC power for a minute and started over, same result. Checked speaker wires and no loose connections. I did find one unused speaker wire from the installer and taped the ends to be safe. I read somewhere to try to change speaker settings to "small" and up crossover frequency to 100. I did both and still no results.
When the sound comes on, it is very "tinny". A moment ago it seemed like center channel was not working and left front speaker sounded bad. This system has been working flawlessly and filling the room with sound until today. Any help to get me running again is appreciated.
During middle of IRON MAN2 Blu-Ray, the receiver shut down. I turned back on and get same results. I shut down AC power for a minute and started over, same result. Checked speaker wires and no loose connections. I did find one unused speaker wire from the installer and taped the ends to be safe. I read somewhere to try to change speaker settings to "small" and up crossover frequency to 100. I did both and still no results.
When the sound comes on, it is very "tinny". A moment ago it seemed like center channel was not working and left front speaker sounded bad. This system has been working flawlessly and filling the room with sound until today. Any help to get me running again is appreciated.