Jump to content



Sign up for a free account to remove the pop-up ads

Signing up for an account is fast and free. As a member you can join in the conversation, enter contests and remove the pop-up ads that guests get. Click here to create your free account.

Photo
- - - - -

Decision: Component video/audio cables or HDMI cables???


  • You cannot start a new topic
  • Please log in to reply
3 replies to this topic

#1 of 4 OFFLINE   lptudor

lptudor

    Extra



  • 18 posts
  • Join Date: Jan 16 2007

Posted September 11 2007 - 05:47 AM

I'm trying to figure out whether to use a HDMI splitter to split a HDMI output signal and connect two televisions via HDMI (by using a HDMI splitter for my single HDMI output) or whether to use the HDMI output and the Component Video/Audio outputs to send the signals. I want to ensure I get the best HD signal I can send to both TVs, so wondered if Component Video/Audio Coaxial RG-6 18AWG 75Ohm CL2 Rated Cable would do just as good a job as HDMI cables. Any advice?? If not, can someone explain whether HDMI splitters work well (and whether you need one with a built in amplifier)?

#2 of 4 Guest_Eric Kahn_*

Guest_Eric Kahn_*
  • Join Date: --

Posted September 25 2007 - 04:19 PM

I have this same question, just ordered dishnetwork HD and the reciever only had one hdmi output but it also has a component output, I have to hd tv's to hook up so can I use the hdmi for one and the component output for the other one?

#3 of 4 OFFLINE   lptudor

lptudor

    Extra



  • 18 posts
  • Join Date: Jan 16 2007

Posted September 25 2007 - 05:28 PM

Eric: Here's what I ended up doing. I ran the HDMI output to my AV receiver and from there to a powered splitter that I bought at monoprice.com (100 bucks). Then I sent the HDMI signal to both TVs. I sent the "TV 2" signal to the second TV with a regular coax cable. So TV 2 gets the HD programming and SD programming (in case we want to watch something different on TV 2. My understanding is that you could use any combination of the outputs from theTV 1 ouptut to send the HD signal to both TVs (so you wouldn't need a splitter if you didn't want. I went with the single HDMI cable through the receiver and then to the splitter route so that I could send both HD programming from the dish receiver (ViP722) and from my HD DVD player to both TVs. If that was your objective, you'll need to reassess. Otherwise it sounds like you're ok.

#4 of 4 OFFLINE   Jeff Gatie

Jeff Gatie

    Lead Actor



  • 6,531 posts
  • Join Date: Aug 19 2002

Posted September 26 2007 - 03:06 AM

With a TV tuner signal, there should be little to no difference between HDMI and component. HDMI becomes necessary when you factor in copy protected materials (such as in upscling SD DVD's), or when it is required for HD audio formats from HD DVD or BluRay. Since HD cable/satellite uses no copy protection for HD content, I wouldn't worry about using component.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users