1. Guest,
    If you need help getting to know Xenforo, please see our guide here. If you have feedback or questions, please post those here.
    Dismiss Notice

Subsonic filter

Discussion in 'Archived Threads 2001-2004' started by Drew Eckhardt, Jun 7, 2001.

  1. Drew Eckhardt

    Drew Eckhardt Stunt Coordinator

    Joined:
    May 10, 2001
    Messages:
    247
    Likes Received:
    0
    I have a (passive, separate power amplifier, cross over in my preamp/processor) ported sub, currently limited so it doesn't bottom if (when) it receives subsonics (like those present in the limiter configuration test tones on my preamp/processor). Getting rid of the lowest frequencies and raising the limiter to just shy of amp clipping seems a better idea.
    Contrary to urban legend, my BFD has no problem passing tones < 20Hz, so that doesn't work for me.
    Fortunately, I'm a professional geek with soldering iron, box of passive components, and a couple of opamps.
    A 24dB/octave filter is trivial, but I haven't a clue as to
    how I should pick a -6dB point. Suggestions?
     
  2. David-alexander

    David-alexander Stunt Coordinator

    Joined:
    May 28, 2001
    Messages:
    218
    Likes Received:
    0
    Hi!
    I too have the BFD but I have a subsonic filter on my amp.
    So, you're sure that even by cutting twice at 20hz, by 6 or 12dB/octave ( Berhinger recommends twice 1/2 cuts instead of one full cut to lower distorsion), the BFD still let pass the sub-20hz frequencies?
    It is rated for 20hz-20khz bandwith.
    thanks
    ------------------
     
  3. Drew Eckhardt

    Drew Eckhardt Stunt Coordinator

    Joined:
    May 10, 2001
    Messages:
    247
    Likes Received:
    0
    10dB below reference is the comfort limit for me with movies, making my target 105dB in the 20-120Hz LFE range.
    Measured in room response at my college couch is a just a bit better than that at 20Hz, so I don't want a BFD filter centered at 20Hz and therefore haven't played with one. For that matter, a wide filter centered even lower (can I set a filter for 20 - 20/60ths using the fine adjustment?) would have frequencies > 20Hz in its band and would still be undesireable.
    That said, without a filter at 20Hz, the BFD most definately passes sine waves down through 10Hz (the limits of my test CD; my signal generator only goes down to 20Hz) although I haven't measured the attenuation.
     

Share This Page