Should receive my receiver this week, but now I have some questions after reading posts on this forum and looking over the owners manual: 1. Will I have to assign the digital inputs even if I use the default settings (i.e. #3 for dvd via coax) 2. Do you have to disable the inputs not in use, or is there any way to do this 3. Can I just run the digitalaudio from the dvd to the receiver, and run the video and analog audio to the tv. 4. The manual recommends connecting the analog from the satellite to the receiver - why is that, even though I will be connecting the digital audio to the receiver. 5. I will have a separate sub, should I choose "plus" in the sub setup, should I use Bass Peak, 6. What should I set the sub's volume to prior to running the MCAAC, the manual states approximately 1/2. 7. Should all speakers be set to small or only the fronts to gain maximum performance, shoud crossover be 80? 8. Since I don't have a tv that uses component, do I have to assign the component inputs on the receiver 9. Is the channel level & delay set during the MCAAC 10. The manual talks about Acoustic Calibration Equilization, Trim & Dynamic Range control - what do these do. Sorry for so many questions, but I am excited about getting my receiver and can't wait to hook it up.