1. Guest,
    If you need help getting to know Xenforo, please see our guide here. If you have feedback or questions, please post those here.
    Dismiss Notice

Do I have this right??

Discussion in 'Home Theater Projects' started by jonathanMo, Jun 22, 2006.

  1. jonathanMo

    jonathanMo Member

    Joined:
    Jun 4, 2006
    Messages:
    5
    Likes Received:
    0
    So I want to pre-wire for a multisource/multizone system do I just need to run 2strand speaker wire from the reciever to each zones volume control and from the control to the speakers ,and cat 5 to each room for use of keypads in the future.

    I guess what i should say is what would you guys run for wires if you were planning on doing a multisource/multiroom system in the future but dont have the money for all of the equipment right now. I would also like to be able to play music from my computer throughout the system what will that require for wiring?


    Thanks for the help i need to sheetrock in a couple of weeks and i want to get this house wire for all possible expansion.


    Thanks Jon
     
  2. mylan

    mylan Well-Known Member

    Joined:
    Jan 6, 2005
    Messages:
    1,686
    Likes Received:
    0
    If you'll go back to your earlier posts, you will see we have already answered this question for you. Our answers will be the same, in a nutshell; you'll need to run a 16/2 speaker wire for each speaker, and from that you will need to run a 16/4 bundle to the location of your amp, receiver, etc. additionally you will need a run of cat5 to a volume control/keypad.
    I have much experience with this as I have just installed a whole house audio system in my house, which was made easier because I pre-wired in this manner. If you cannot afford to actually install everything now, then I suggest you install a single or double gang wall plate so that when you are ready to install the system, all you will have to do is remove the blank wall plate and connect everything. My recomendation to you is to consider a true whole house solution, like the Russound CAV 6.6 with Uno 2 keypads, this will give you excellent control features that will be easy for the entire family to enjoy. Make sure to consider where you want the keypads installed and just put blanks there until you get ready.
    If you need further assistance, the guys over at www.avsforum.com can help. Some of them are actual installers and have done many of the same types of systems you are considering.
     
  3. Scott Tucker

    Scott Tucker Well-Known Member

    Joined:
    Jul 22, 2002
    Messages:
    231
    Likes Received:
    0
    I would run 16/4 and Cat5e from home run to each touchpad location and then on the speakers. This will cover most future needs.

    Scott
     

Share This Page