1. Guest,
    If you need help getting to know Xenforo, please see our guide here. If you have feedback or questions, please post those here.
    Dismiss Notice

DIY sub using HT amp

Discussion in 'Home Theater Projects' started by Steve Weeks, Mar 29, 2003.

  1. Steve Weeks

    Steve Weeks Stunt Coordinator

    Joined:
    Jul 12, 2002
    Messages:
    58
    Likes Received:
    0
    I have a channel on my amp that I am not currently using, and I am looking to build a sub. So, what I am wondering is this. Can I use this amp for my sub? I have been looking over old posts here, and I have seen references to a rumble filter. I would assume that amps intended for use with a sub would have this filter, and other amps would not. Do I need to do anything, or are there any potential concerns, with my proposed project? T
     
  2. TimForman

    TimForman Supporting Actor

    Joined:
    Dec 4, 2002
    Messages:
    847
    Likes Received:
    0
    Other than adequate power and a low band pass filter (crossover) I can't think of anything. Both of my subs are passive and share channels on a two channel pro amp. Works ok for me.
     
  3. PaulDF

    PaulDF Second Unit

    Joined:
    May 17, 2002
    Messages:
    354
    Likes Received:
    0
    If you build a sealed sub, you don't need the rumble filter. If you build a ported sub, you just need to be aware that frequencies below the tuning point will push your sub way too far.

    I ran my sub with a regular receiver for a while, it worked fine. Just be realistic with your volume level during extremely low bass signals.
     

Share This Page