1. Guest,
    If you need help getting to know Xenforo, please see our guide here. If you have feedback or questions, please post those here.
    Dismiss Notice

Converting to battery power

Discussion in 'Beginners, General Questions' started by ryan.sager, Nov 20, 2008.

  1. ryan.sager

    ryan.sager New Member

    Joined:
    Nov 20, 2008
    Messages:
    1
    Likes Received:
    0
    I recently bought a new entertainment center and unfortunately the previous owner modified the cabinet lights by snipping the ends of the cords off and wiring it directly to a wall switch. I hate the way it looks with the lights off and would like to, once again modify it, this time by, converting the power source to batteries and installing a small switch in the back to turn both of the lights on and off simultaneously. I'm sure a 9V battery, or perhaps a few, would be enough to power the two cabinet lights. I'm not exactly sure how to go about doing this though.

    The light panel reads VERBATIM as follows

    Cabinet Light UL Listed E210130
    Warning-Risk of fire-MAX 25 watt,
    Type T bulbs
    Place light source no closer than 3/8" to any surface
    120V 60HZ AC only

    Any Ideas/Help would be greatly appreciated.

    Very Respectfully,
    Ryan
     
  2. Greg_R

    Greg_R Well-Known Member

    Joined:
    Apr 9, 2000
    Messages:
    1,998
    Likes Received:
    0
    Location:
    Portland, OR
    Real Name:
    Greg
    The bulbs run on A/C power. You cannot feed them with a DC source directly... it simply will not work. If you want to go the battery route, you will need a DC-AC power converter (not the cheapest item). These items are popular in car audio and RV circles for powering equipment and are typically intended to run off a car battery. You might be better served switching to a DC powered light source and replacing the existing cabinet fixture. Those push-click puck lights do a good job and are ultra easy to install (peel off sticky paper, then stick to the wall).
     
  3. Cowbell

    Cowbell Member

    Joined:
    Jun 16, 2008
    Messages:
    24
    Likes Received:
    0
    Someone correct me if I'm wrong, but I believe the formula is:
    DC voltage * .707 = AC voltage.

    To figure out how much DC voltage you'll need to run a 120V ac light bulb.
    You'd take 120Vac/.707=169.7 Vdc. Not really practical I think.
     

Share This Page