I just recieved/purchased 4 VWS-100 by .2sr, found on ebay http://cgi.ebay.com/BASS-SHAKERS-lik...QQcmdZViewItem for $70/pair. Anyway, I didn't realize that thease bass shakers are rated at 2ohms. I have a Pio Elite TSX82 amp, which I will use the pre-amp output to connect my old JVC 887 (110w/channel)? Dolby digital amp to run the shakers. I have a question on connecting these shakers. I believe that the JVC is rated at 8ohms, but believe that it is switchable to 4ohm capability for front speakers, I may be wrong though. This is how I plan to connect them for 4ohms: I will split the LFE cable out of the Pio Elite, then input them into the JVC DVD terminal w/ another split. I will then connect JVC + to + in 1st shaker, then - from shaker to + in OTHER shaker, then - from shaker to - in JVC, do this w/ R/L channels. Is this correct? will this then output at 4ohms? If I decided to do 8 ohms, would I do this same thing, but w/ all 4 of the shakers into just 1 speaker terminal? What would be the most effecient way? thanks for the help!!