1. Guest,
    If you need help getting to know Xenforo, please see our guide here. If you have feedback or questions, please post those here.
    Dismiss Notice

Adjusting Convergence on Hitachi

Discussion in 'Displays' started by GregHe, Feb 1, 2004.

  1. GregHe

    GregHe New Member

    Joined:
    Feb 13, 2003
    Messages:
    3
    Likes Received:
    0
    Hello,

    I have a Hitachi 60EX01B 60" (basically same TV as the 50EX01B) rear projection TV. My convergence is a little off on the picture. The built in convergence utility is only for adjusting up/down/left/right of the entire picture, not sections of the screen.

    I have found controls on the inside of the TV for performing a fine tuning of convergence. I was able to adjust it a little bit, but I cannot find a way to get the TV to display a test pattern for adjusting the convergence. The built in utility only displays a plus in the middle of the screen which doesn't help me with any thing other than the middle.

    Does anyone know how to get this TV into a test mode for adjusting this?

    Also, are there any beginners guides to convergence on a TV? Like which parts of the picture should be done first based on my available controls? I'm sure I can figure it out on my own, but any info would help. Thanks.
     

Share This Page