New Posts  All Forums:Forum Nav:

Onkyo TX-SR600 no analog output

post #1 of 2
3/10/11 at 1:49pm
Thread Starter 

O know this is out of the HT realm, but I am stumped.  I have been using my TX-SR600 in our livingroom HT set-up for some time with no issues.  I wanted to add a I-pod and CD player for music.  The problem is I can not get any sound from my analog sources.  I used my OSD set-up to config per manual with no luck.  I know that the defult setting for OPT 1, but I have the OPT1 set to my FIOS box.  If I am using OPT1 for another purpose does it cancel out the CD input.  I tried the Tape input with no better results.  Any ideas would be helpful.

Reply
post #2 of 2
3/10/11 at 8:53pm

I know you said you used the OSD setup but most receivers default to the digital connection unless you change it to analog. Sometimes there's a button on the remote labeled "Signal Select" which allows you to switch from a digital input (such as optical or coax) to the analog one. You have to start with the simple stuff smile.gif .

Reply
New Posts  All Forums:Forum Nav:
  Return Home