New Posts  All Forums:Forum Nav:

Ok hows it done?

post #1 of 3
10/19/10 at 5:00pm
Thread Starter 

So I finally built a custom sub for my home theatre (DB10 Titanic, custom configured by RobertJ), How on earth do I set my speakers to "small"?? I was admitedly up to late configuring the new setup with audeyssey, but I cant find how to do this. Please help!

The reciever is an Onkyo TxSR606

 

Thanks!

 

Aaron

Reply
post #2 of 3
10/20/10 at 6:46am

Aaron,

 

Check page 72 of your manual.  It's a bit tricky, as some manuals have stopped using the "Large/Small" desgination in favor of "Full Range/crossover frequency".

 

I'm sure Robert will jump in with a recommendation on what the optimal crossover should be for your system (you could probably start in the 80-120Hz range).

 

Nice job, by the way.  I've never built my own speaker, but from what I've read on the forum, you won't be disappointed with the results!

Reply
post #3 of 3
10/20/10 at 8:53am

I always start with 80hz and go from there.  My current speakers can play lower so I think my subs are crossed over at 65hz.  My new speakers don't play that low so I will probably end up at 80hz.  It really depends on your speakers, sub and room interaction.

Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Receivers/Separates/Amps