post #1 of 1
6/17/09 at 7:42pm
Thread Starter 
Set-Up:
1 Sony Pre Amp; 1 output split to two amps
2 Sony 9000ES Amps
2 Niles Speaker Switches; Each going to 6 sets of Niles Volume Controls
12 sets of B&W In wall Speakers.

This set up was working fine for about a year until now. The right amp keeps blowing (this is the third time having it repaired)
Troubleshooting steps taken so far:
Unplugged speaker wires from Niles switch and from volume control. Used an old multi meter to test for resistance on all the lines going to that switch. No resistance reported.
Could it be the multi meter is not sensitive enough?

Any other Ideas to test? What is the next step?

Thanks guys!
Reply