New Posts  All Forums:Forum Nav:

Onkyo 607 Bi-Amp Question  

post #1 of 3
6/11/09 at 11:53am
Thread Starter 
I'm currently getting started on piecing together audio gear to finish up my home theater and have run into a small bump in my choice of receiver. I had been going between getting the Onkyo 507 and the 607, and had pretty much settled on the 607 because of its slightly higher power output, ability to expand past 5.1 in the future if I eventually have the room, and most importantly the ability to bi-amp on an output.

However when I looked into it more, I found out that it was only able to bi-amp on the fronts, sadly my fronts are full range and my center is Bi-amp. So my question is, does anyone know if you are able to reconfigure the outputs to allow you to bi amp a different channel than the fronts?

Thanks.
post #2 of 3
6/14/09 at 2:33pm

Re: Onkyo 607 Bi-Amp Question
Quote:
So my question is, does anyone know if you are able to reconfigure the outputs to allow you to bi amp a different channel than the fronts?
If it can be done, the manual will tell you how to do it.

Regards,
Wayne A. Pflughaupt
post #3 of 3
6/16/09 at 4:59pm

Re: Onkyo 607 Bi-Amp Question

http://www.hometheaterforum.com/htf/...-question.html
New Posts  All Forums:Forum Nav:
  Return Home
This thread is locked