New Posts  All Forums:Forum Nav:

Best way to connect my Sanyo projector to blu ray?

post #1 of 4
2/21/09 at 3:45pm
Thread Starter 
I have a Sanyo HD projector capable of 108oi but it does not have a HDMI. Is there a receiver that I can use to connect all my components to that will convert hdmi to componet?

My projector is a pvl60ht from Sanyo.
It has component, RGB S video, composit and Y,Pb/Cb,Pr/Cr (BNC type).
I would like to be able to hook my High def stuff (360, blu ray, Directv) to the receiver and have it all connected to the projector.

Thanks
Jim
Reply
post #2 of 4
2/21/09 at 9:38pm

Re: Best way to connect my Sanyo projector to blu ray?

The answer to question #1 is: I don't think so.
Do you have a receiver with 3 component inputs? If so, you would hook up your 3 sources listed to "component in" on receiver. Then you would run one component cable from "component out" on receiver to projector. Then you would run audio cables from each component to receiver.
Reply
post #3 of 4
2/22/09 at 2:49pm
Thread Starter 

Re: Best way to connect my Sanyo projector to blu ray?

i was afraid there was no way to convert HDMI to another high def type.
thanks

Jim
Reply
post #4 of 4
3/6/09 at 10:51pm

Re: Best way to connect my Sanyo projector to blu ray?

I am not sure if you are aware but because you are using the componant cable as opposed to HDMI you will not be able to take your SD dvds and have the Blu Ray player upscale them to 1080i, they will be playing at 480i. You will only be able to achieve 1080i resolution when you are playing Blu Ray discs on your Blu Ray.
Reply
New Posts  All Forums:Forum Nav:
  Return Home