- make that COMBINING black-and-white separation masters to create a new pre-print element (I wish you could edit topic headlines here)...
I'm not sure if this is feasible, but it's something I've been wondering. I know from reading a lot about color film restoration (mostly stuff regarding the work you've done and quotes from you) that it's the yellow layer that fades first on color negative, and when the yellow layer is gone, one has to go to the black-and-white separation masters and recombine them optically (or nowadays, digitally), which is what you of course did in order to restore SPARTACUS. My question is, if you have a set of black-and-white separation masters, and a negative with a faded yellow layer but largely intact cyan and magenta layers, could you combine just the yellow separation master with the faded negative and create a new, printable element with good color? I was wondering this because I figured it would be easier to match up two elements instead of three, plus I'd imagine you'd get better results if you were using the original negative as the cyan-and-magenta record over two black-and-white elements that are optically printed. Is it possible to do this- combine original negative with a faded yellow layer with the black-and-white yellow separation record- or do you have to use the three black-and-white seps?
Vincent
I'm not sure if this is feasible, but it's something I've been wondering. I know from reading a lot about color film restoration (mostly stuff regarding the work you've done and quotes from you) that it's the yellow layer that fades first on color negative, and when the yellow layer is gone, one has to go to the black-and-white separation masters and recombine them optically (or nowadays, digitally), which is what you of course did in order to restore SPARTACUS. My question is, if you have a set of black-and-white separation masters, and a negative with a faded yellow layer but largely intact cyan and magenta layers, could you combine just the yellow separation master with the faded negative and create a new, printable element with good color? I was wondering this because I figured it would be easier to match up two elements instead of three, plus I'd imagine you'd get better results if you were using the original negative as the cyan-and-magenta record over two black-and-white elements that are optically printed. Is it possible to do this- combine original negative with a faded yellow layer with the black-and-white yellow separation record- or do you have to use the three black-and-white seps?
Vincent
