New Posts  All Forums:Forum Nav:

klipsch sub advice

post #1 of 3
4/23/08 at 7:48pm
Thread Starter 
hey guys.I have bought a klipsch synergy sub-10. the manual says i can change the frequency from 40-120 hz for upper frequency cutoff. how am i supposed to do that?
Reply
post #2 of 3
4/24/08 at 2:32am

Re: klipsch sub advice

You should set the crossover frequency on the sub to 120Hz (the highest possible point). Then set the crossover you want to use in your receiver. The setting in your receiver depends on the capabilities of your other speakers. I would start by setting your receiver's crossover to either 100Hz or 80Hz. If you'd like, you can post your other speakers and get some suggestions on where to set the crossover.
Reply
post #3 of 3
4/24/08 at 10:27am
Thread Starter 

Re: klipsch sub advice

i have not bought new speakers yet. presently i have connected the sub to my older speakers, which have a frequency range of 150-20,000 Hz - so i guess i don't have to set the crossover now.i have just been experimenting with my new sub's features and i couldn't figure out how to change the frequency range. maybe i'll post a reply in the same thread as soon as i buy new speakers and count on you for more help.
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Speakers and Subwoofers