How to reset a receiver?

Antonio_D · 12-13-2005, 04:34 PM

I guess i played a little too much with the settings on my Audio/Video receiver lately.

I would like to reset it to its factory settings.
How can i do it?
My model is a: Pioneer Elite 54 tx

Thanks,

JeremyErwin · 12-13-2005, 06:23 PM

somehow htf is acting up. The instructions are below../

JeremyErwin · 12-13-2005, 06:31 PM

From page 64 of the manual

Quote:

Resetting the system
Use this feature to reset the system to its factory default
settings.
1 Switch the receiver into standby.
2 While holding down the front panel TONE
button, press and hold STANDBY/ON for about three seconds.
The display shows RESET?
3 Press the front panel TONE– button.
The display shows OK?
4 Within 5 seconds, press TONE+.
The display shows OK
and the receiver should now be reset.
Note
•Make sure the multi-room feature is switched off
when doing this.
•If the receiver is unplugged from the AC outlet for a
month or more, it resets to the default settings.

Antonio_D · 12-13-2005, 07:55 PM

Thanks a lot Jeremy,i'll try that in a few minutes.



Skin Chooser:	Contact Us - Advertising Information - Home Theater Forum - Archive - Top