[HTenthusiast]

I have a slightly glaring/annoying problem. I have unfortunately, 20/10 eyesight which although is very good, is also very bad because I can pick up the smallest image imperfections without even trying!! My DLP set has somehow gotten some dust/dirt of some sort between the protective outer screen and the screen itself. Is there any way to remove the outer screen to clean it out?? It's absolutely killing me!! I try so hard not to notice it and no matter how hard I try, I still find myself looking dead at that damn spot!! Please chime in w/some advice.

[Gregg Loewen]

no problems. Pull it apart and clean it.
Be very aware that since you are not in a sterile environment you may be introducing more dirt then you will be removing.
Perhaps your extended warranty will cover it (part of the cleaning service) ??

Good luck!!

[HTenthusiast]

Is there any special method to take it apart? Or just find all the screws and have at it? I have no warranty. It was a floor demo unit, hence the reason I got it for only $1200......lol.

[allsmiles277]

Lamp has dust on it...clean with appropriate cloth that will not leave more dust on lamp.

[HTenthusiast]

Ok, I took the screen part apart today. I found out that somehow, dirt of some sort was wedged inbetween the protective outer screen and the inner lens/screen. After I separated them, I of course tried to clean them. The projector lens was indeed dirty, so I took the liberty of cleaning it w/a good duster. My problem now is I tried to clean the outside surface of the inner lens/screen and apparently, it's a very delicate piece. I don't know what it was that was stuck to it, but it took some effort getting it of. I used a damp cotton towel and rubbed it off. In so doing, I messed up the outside surface of the screen. I need a replacement!! Does anyone know where I can buy that part for this set?