08-29-2004, 09:52 PM
|
#12 of 12 
|
|
Member
Join Date: May 2001
Local Time: 03:49 AM
Local Date: 01-08-2009
Posts: 1,021
|
Quote:
|
If you are using an analog source, I believe the Aragon has a gain setting....check the owner's manual.
|
Yep , that was it Ricky, thanks alot. Pretty neat feature too.
Thanks A bunch!
Analog Input Level
By default, each analog input on the Soundstage is set to accept a standard 2 volt input signal. If
the output voltage of the source connected is above this level, and clipping occurs, the Soundstage
will automatically lower the analog input level to the point just below clipping. Pressing the
SHIFT button, and then pressing the LVL UP (FF) or LVL DN (REW) button on the remote
control will manually adjust the analog input level up or down respectively in 1/2 dB steps. For
each 1/2 dB step, you must press the SHIFT button. If the analog input level is raised too high,
once clipping is detected it will automatically lower to the optimum level.
Separate Audio and Video Input Switching
The Soundstage allows for separate Audio and Video switching, but this feature must be turned on
in the custom menus before it can be used. See the Custom Menu section for further details. The
first time an input is selected, using the input selection buttons at the bottom of the remote control, |
|
|
|