Posts by Pete H

To this point I have used my Pioneer Elite DV-47A for dvd's only. I use the optical digital out to the av receiver. Could I run into any problems connecting the coaxial digital output to my CDP and single ended analog outputs to...

I have been where you are. I wish you better luck than I had. Below is a quote from a guy that makes a lot of sense to me. I have not tried it myself. "We used one heavy ground wire for all four circuits with pigtails right by...

Chu B&W does not, and based on my effort, will not make speaker wire recommendations. They do suggest wires with an impedance under 0.1 ohm across all frequencies. That's all I can tell you. Andrew I don't believe is...

Not if the figures are in yen.

The B&W manual for my speakers state: "Bi-wiring is the preferred method of connection and involves the use of separate cables from the amplifier to each pair of terminals. The separation of the signal paths improves the...

Cables do, beyond doubt, make a difference in a system designed for music. The difference is small but important to many. Cable improvement dollars should be among the last dollars spent. Of course, the vast majority of the...

Sure, many times. Great way to improve your gear.

Tube traps are fairly expensive. The following website has construction information and lots of useful information. http://www.geocities.com/jonrisch/

I think Kimber matches very well with B&W. You could get a loaner set from fatwyre.com and try for yourself. (Another good possibility would be Discovery cables.)

I have two amps both two channel. Simaudio W-5 190 wpc and the Rotel RB-1090 380wpc