Posts by TexasStation

Ya, I will go ahead and give it a shot. I have a Denon AVR-3808 receiver. I've spent a lot of long, frustrating months trying to get the sound right using Audyssey, but had a lot of bass problems in there (too much bass in the back and...

Sorry if I didn't clarify myself, but I was actually looking to disconnect my sides, then connect my back surrounds to Surround A on the receiver, thus sending the 5.1 output to the back surrounds, instead of the sides.

I'm basically thinking of disconnecting the sides and using the backs instead for 5.1

I have a dedicated front projection media room with a 7.1 setup, and I've never been quite happy with the sound coming from the surrounds. I have two rows of recliners, with the side surrounds (Paridigm dipoles) wall-mounted on the side...

I, too, am a little curious about the results from the MultiEQ setup on my Denon AVR-3808. I'm running a Paradigm 7.1 system with Studio 60 mains, CC-590 center and ADP-390 dipole surrounds. Anyway, it set up my mains and center as...

I just purchased the Audyssey package (Dynamic EQ and Dynamic Volume etc.) for my Denon AVR-3808CI receiver. After starting the update, the GUI just stays at "please wait. authenticating" and the display on the receiver stays at 1/14...

Hello, Basically my situation is this... I have a dedicated media room approx. 16 X 21', with two rows of 4 recliners (back row on a 6" riser). I use the Audyssey calibration on my Denon AVR3808 receiver, and the back row (especially...

Here's my situation. We just built an enclosed media room, approx. 16' X 19'. I have two rows of 4 theater recliners, with the front row about 11' from the screen and the back row about 2' from the back wall on a 6" riser. The problem...

I tried moving the sub again (now it's near the right rear corner) and it actually sounds pretty good at my main listening position (front row, middle seat), but still all the seats in the back row (which are right near the back row)...

Ok...call of the dogs. For whatever reason, after I replaced/reseated the sub cable on the back of the receiver and turned it back on, it started working again. I would still be interested to know what might've caused this to happen and...