Posts by Dale B

Been a while but was wandering if a hdmi switching reciever has to be on to work. What I am asking is, if I want to watch dtv with hdmi cable hooked up, will the reciever have to be on for the audio and or video to work? The reciever is...

Hi Joe, go to hometheaterspot and on the right you will see manufacturers spot or something like that. I just went there and your problem was just a few lines down. Good luck.Sorry,but you will have to scroll down to onkyo.

Best buy has the yamaha sub on sale for 99 dollars this week.

Hi Todd. I picked up a new sub at radio shack a couple of weeks ago. It is a new brand they are carrying called accurian. It is fairly small but puts out good bass for an 8 incher. I paid a whole 99 dollars for it. It replaced a 8 inch...

Thanks for the advice. I set the crossover to 120 and it sounds good.I really wasn't to sure what the settings mean, but I have a clearer picture now. Thanks again.

Hi all. I have been reading a long time about crossover settings on receivers. I just can't figure it out. My onkyo has settings from 60 to 150htz. I have very small paradigm speakers, the cinema 70 series. What setting would send more...

Thanks John. I don't listen very loud at all.

Hello all. I just purchased 5 cinema 70 speakers from Paradigm. After I hooked them up I read where they are only 40 watts max. power input. I am powering them with an Onkyo 502 receiver. Should I be concerned about this 40 watt max?...

Hi Edward. I had the xr-45 and a technics receiver and both were just like you said. The fronts can not be adjusted, just the center, rears and subwoofer. I guess the fronts are pre set and all the others can be set to match the fronts....

Hi Ray. Just went through the exact same thing. I had both systems at the same time. I had the 300 sub not the 400. For music the point 5 system was better, but for movies I find the micra 6 to be better. Also one thing to think about...