Posts by Brian H

Does anyone have a line on where I can download the IR codes for my Zektor HDS4.2 switch? I had pulled it out of my system (and my Pronto TSU7000 config), but need to re-install it. I checked the Zektor site, and it appears that they...

Well, after reading the Anchor Bay FAQ you provided, that sure looks like the problem. However, I am pretty positive that I have used this configuration with my Blu-Ray player with no problem in the past (although I am only probably 99%...

The signal path is as follows... Sony BDP-S1 DVDO iScan HD Lexicon MC-1 Sharp XV-Z10000 Projector I am running component video from the Sony to the iScan, and DVI from the iScan to the projector. Audio via coax from the Sony to...

Arthur/Ted, Thx for both your comments. Very much appreciated. I struggle with choking down a Lexicon MC-12. I've been in the Lexicon line since my CP-1 (I think that was the model?), and hate to leave them. Just seems like too...

Haven't been here in awhile, but getting ready to refresh my electronics and looking for some advice. Current set-up includes a Lexicon MC-1, Aragon 8000 series amps, and ML speakers (Quests on the front mains and center). I have Quest...

First, I think the Aragon amps are amazingly accurate. Second, does anyone know how to set the bias on them? Especially if the Klipsch buy out is having an impact on Aragon products, I need to know how to set the bias on them as I...

I have been a supporter of Aragon amplifiers for years. Currently, I am running an 8008ST, and 8008X3 in my home theater. The only issue I have ever had was that occassionally 'the bias' has to be adjusted to keep them from running too...

No, I never thought of contacting DirecTV. Probably what I should have done, is just buy my new dish and HD receiver with their installation included. Then I would have to deal with this.....

Fred, I think I understand you and thanks for the suggestion. I didn't realize that was a viable option. The only issue is that then I have to pull RG6 across the attic to the outside wall, down to the ground block, and then back...

My DirecTV dish is currently mounted on the side of my house and close to the service entrance. When I installed it, it was simple to run a ground wire down the side of the house to the house ground and be done with...