Home Theater Forum  ›  Forums  ›  Home Theater Hardware  ›  Receivers/Separates/Amps  ›  Digital Coaxial output amplifier
Forum Nav More Forums | All New Posts | New Thread

Digital Coaxial output amplifier

#1
Rating: 0
10/4/09 at 8:39am
  • Joined: June 2006
  • Post Count: 45
I currently have a dvd player connected via coax digital audio to a Yamaha Amplifier. Some of the films are loud and most are low (tried different dvd players also) . Is there an amplifier to increase the input to the amplifier to increase the input in the coax of the amp?

thanks in advance
Export to Wiki
#2
Rating: 0
10/4/09 at 9:52am
  • Joined: May 2003
  • Location: Eastern NC
  • Post Count: 1,761
I doubt seriously that it's the dvd player or digital coax cable. The player sends the full signal to the receiver/amp, where it takes control. Try a different dvd player. If same thing happens, the problem is with the Yamaha.

I'd also double check the speaker connections, to make sure the phase is right (+/-), with all of them, at both ends. The phase being wrong can cause lower volumes on that speaker(s), I think, but then it would be constant, and not loud for some and low for others.
Samsung HL61A750 (LED DLP)            Onkyo TX-SR805
Oppo BDP-83 Blu ray                                  Polk Audio LSi9
Polk Audio LSiC                                  Sony SS-MB100H
JBL PSW1200 (Sub)                        ...
Export to Wiki
#3
Rating: 0
10/4/09 at 10:45am
  • Joined: January 2004
  • Location: Mechanicsburg, PA
  • Post Count: 1,116
Some films are loud and some are low?  Could be difference between DTS and Dolby?  Have you calibrated your speakers?  Maybe there is a separate calibration for DTS and Dolby (like Harmon Kardon's).
My Home Theater
Our DVD Collection
Dolby and DTS Plaques (downloads)
Export to Wiki
#4
Rating: 0
10/5/09 at 12:17pm
  • Joined: August 2002
  • Location: Mass
  • Post Count: 6,031
The digital coax is a digital signal.  There is no "amplifying" a digital signal.  The culprit is probably calibration of the receiver and speakers.  Your speakers have to be set so they are all putting out the same volume.  If they aren't calibrated, the surrounds and mains can be louder than the center, which will drown out the dialog, making the dialog seem too low.  List the model number of the Yamaha and we can tell you how to calibrate it.
Export to Wiki
#5
Rating: 0
10/5/09 at 12:31pm
  • Joined: April 1999
  • Post Count: 1,573
Also check the DVD player audio setting, make sure it is set to "bitstream" not "PCM".

What are your speaker size settings, did you check levels with a sound meter?

Also realize that DVD will often have a different average volume compared to TV channels, for example, there is greater dynamic range.  The average volume for say the dialog might be rather low to give headroom for very loud effects sequences. That's what the volume knob is for, you'll sometimes have to turn it up compared to normal TV.  The dynamic range can be reduced by "midnight" / "late night" mode settings if the explosions get too loud after the volume has been raised to hear the dialog.



Export to Wiki
Forum Nav More Forums | All New Posts | New Thread