Home Theater Forum  ›  Forums  ›  Home Theater Hardware  ›  Audio/Video Sources  ›  Messed up dads settings on AVR 645
Forum Nav More Forums | All New Posts | New Thread

Messed up dads settings on AVR 645

#1
Rating: 0
9/20/09 at 7:55pm
  • Joined: September 2009
  • Post Count: 3
Basically i was rerouting some wires to make my dads theatre look good, and i guess when i unplugged his AVR- 645, it reset the settings? I labled "video-3" as the xbox 360, and now it just shows video -3.

Is there any way to get those settings back (probley not, but yea..)? I tried setting it up with the microphone and with the OSD...but having problems with the subwoofer making a farting noise. The subwoofer is Velodynes' DPS-10. The speakers are infinity, and are rather tall (4 foot?) and its a 55inch hitachi TV.

Is there any way to redo settings, or fix subwoofer?
What are the chances of me breaking the subwoofer?
Edited by Brandon Rob - 9/20/09 at 8:50pm
Export to Wiki
#2
Rating: 0
9/21/09 at 3:11pm
  • Joined: September 2009
  • Post Count: 3

bump for hopes to get a reply before the launch of ODST.

Export to Wiki
#3
Rating: 0
9/21/09 at 3:14pm
  • Joined: August 2000
  • Location: Southaven, MS
  • Post Count: 4,543
Sounds like you need to get out the owner's manual and reconfigure everything.  This time write down the different settings.
Export to Wiki
#4
Rating: 0
9/25/09 at 4:33pm
  • Joined: September 2009
  • Post Count: 7
Check the channel levels, sounds like you may have the subwoofer channel boosted too high.

It's not impossible to blow out a subwoofer, but you have to push them pretty darn hard, especially a Velodyne. 

Home Theater Guru
www.aperionaudio.com

Export to Wiki
#5
Rating: 0
9/28/09 at 8:30pm
  • Joined: September 2009
  • Post Count: 3
Check the settings on the subwoofer or the reciever?
I noticed when i did the "EZ SETUP" with the mic, setting up the AVR645, it set the subwoofer to like -10dB.

Export to Wiki
Forum Nav More Forums | All New Posts | New Thread