Home Theater Forum  ›  Forums  ›  Hi-Definition  ›  HT Hardware - High Definition  ›  Samsung BD-P2500 DTS-MA
Forum Nav More Forums | All New Posts | New Thread

Samsung BD-P2500 DTS-MA

#1
Rating: 0
9/13/09 at 7:46am
  • Joined: August 2003
  • Post Count: 29
Good Day All!

I just purchased this BD-player yesterday and installed the latest firmware which is suppose to allow DTS-MA decoding I'm utilizing the 5.1 of the 7.1 analog outs due to my receiver don't able to decode Dolby true HD or DTS-MA in the set up you have to select pcm out which i'm using or bit stream re-encoding or bitstream audophile I'm i using correct audio output because i played the new Gladiator on BD and it really didn't impress me I've never hear the new codec's but have hear the core's for year what i'm i doing wrong?

Thanks in advance

Mitz rptv HD 1080i no hdmi
yamaha 5.1 receiver
Export to Wiki
#2
Rating: 0
9/14/09 at 4:27pm
  • Joined: August 2003
  • Post Count: 29
I'm in the wrong area in guess where should I ask for help?
Export to Wiki
#3
Rating: 0
9/16/09 at 12:56am
  • Joined: April 1999
  • Post Count: 1,573
Did you do the speaker setup in the player?

There's really not much difference at all between high bit rate core & lossless, you may well not be able to hear any improvement.  Most difference if any comes from choices made for the mix itself, not the compression scheme.  Lossy compression schemes like DD/DTS are designed so that the lost part is supposed to be nearly inaudible to most people (sounds masked by other sounds, etc.)
Export to Wiki
Forum Nav More Forums | All New Posts | New Thread