HI everyone new to the forum here. Need Help. Just got a Refurbished Denon 1612 for Christmas. Got it all wires up yesterday to an Infinity Primus (8-ohm) Speaker system. Front, Rear, and sub. Didnt connect center channel yet until TV is on the wall. Pressed power for the initial setup and test and tge unit turned on for a few seconds then back off with a blinking red power light. Subsequent attempts yielded the same results. After consulting the manual/disk, I tried a master reset as well as disconnecting the wires, trying it, and reconnecting and trying again. No luck. At this point the manual says call Denon. Well they arent open til Monday so I kept trying and for some reason it eventually turned on. So I watched a movie. This morning it wouldnt turn on again. After enough tries it did so I listened to a cd. Tonight, wouldnt turn on again. More Red Lights. So wtf is wrong with this thing? It just came from the factory...dont they test them before they send them back out? Anything else I can do besides calling Denon on Monday?