Recent content by MasterAudio

I was looking at the new line of Denon "X” series today and thinking of how fitting it would be to my soon to be Atmos set up at home. I’ve owned Denon’s for years and could really use an upgrade. This AVR looks like it would do the trick!

Good to hear that it shouldn't be the power supply. I wish that I could change it to relative. Every AVR I've owned has had relative volume. I've looked everywhere and it says nothing about it. I'd almost rather take relative right now and leave AccuEQ if I had the option to change out some...

Sorry for the numerous posts and the anynet+ comment. Ha. Ignore that.

Anynet+ I followed your instructions and the display didn't flicker at all. It's just weird. I can absolutely notice a difference in output. So weird.

I followed your instructions and the display didn't flicker at all. It's just weird. I can absolutely notice a difference in output. So weird.

AccuEQ had already been run when it happened. I reset and tested and I got the same result. Ran AccuEQ and got the same result again. I can't seem to figure it out.

I powered on my 636 today and all was good. I switched inputs a few times and powered it on and off a few times between activities. All of sudden.. I notice that there is significantly less output. I have the AVR power on with the volume set at 24 (absolute). It used to be a good starting...

Well.. What are the dimensions of the room? Is the listening position up against a wall? What's your budget? Start with these and then go from there, just so we all have a better idea of what you're working with.

Figured out the issue. There was a "Mix Audio Output" option that is only able to be toggled on or off via the original remote. The player must've been re-encoding so it could mix it's own audio to be output by the AVR. I changed it to "HD Audio Output" and now I get DTS and DD on the front...

I'm reading the manual now and it's not saying anything about turning it off.

I don't have an option to turn off Downmix. It only gives me the options 48kHz, 96kHz, and 192kHz. Those are my only options.

I've checked all my settings on the player. I'll check again on my AVR. The only option on the player is HDMI and Dig Coax. You have the option to set bitstream or PCM for both. I got it set to bitstream over HDMI. I don't see why it would decode DTS itself when set to bitstream, but the...

Well...that's what I was hoping for. That somebody else had this player. So...it's not that my issues don't make sense. You specifically just can't help me.

Anybody at all?

Just recently my 1611UD has started to skip/freeze when playing both seasons 1 & 2 of House Of Cards. Only certain episodes that is. Some play all the way through and others start to skip/freeze at random times. I just placed another blu-ray in there to test it out and there hasn't been any...